FabulaTech Forum
        (http://www.virtual-serial-port.com/forum)
      

        Serial Port Solution >> Serial Port Redirector >> Can it monitor statuses of CTS, DSR, DCD and RI.
        
(Message started by: Dison on Jun 13th, 2008, 1:43am)
Title: Can it monitor statuses of CTS, DSR, DCD and RI.
Post by Dison on Jun 13th, 2008, 1:43am
I want to monitor the real-time statuses of CTS, DSR, DCD and RING.  Can Serial Port Redirector make it?
I have seen preset value of these signals, but it seems for raw data only.  How can I use it both on RAW and RFC2217 mode?
Thanks,
Title: Re: Can it monitor statuses of CTS, DSR, DCD and R
Post by Andrew on Jun 25th, 2008, 1:32am
Dear Dison,
Thanks for your request.
Do you need to monitor signal states in real time? Or you wish to pre-configure it?

If you need to monitor signals, you can use any port monitor software.

Thanks.
Title: Re: Can it monitor statuses of CTS, DSR, DCD and R
Post by Dison on Jun 25th, 2008, 1:54am
Dear Andrew,

 Thanks for your kindly response.
 I need to monitor signal states in real time.  I wonder if it's possible without third party solution.

 Thanks.
Title: Re: Can it monitor statuses of CTS, DSR, DCD and R
Post by Andrew on Jun 25th, 2008, 2:01am
Yes, currently it's possible with the help of third-part software only.
If I remember correctly, there are several simple freeware utilities that allow that.
Thanks!
Title: Re: Can it monitor statuses of CTS, DSR, DCD and R
Post by Dison on Jun 25th, 2008, 2:10am
Thank a lot.