FabulaTech Forum
        (http://www.virtual-serial-port.com/forum)
      

        Serial Port Solution >> Virtual Serial Port Kit for Windows CE >> Not working on Yakumo Omikron ?
        
(Message started by: TWKunze on May 24th, 2006, 12:10am)
Title: Not working on Yakumo Omikron ?
Post by TWKunze on May 24th, 2006, 12:10am
I got the trial of Virtual Serial Port Kit CE 4.7.2 but don't get it to work on a Yakumo Omikron.
It has Windows Mobile 2003 installed, and I plan to use a small tracking tool, that receives GPS-information via SMS, and hand the info out to a map software via a virtual COM port.
So I created the new pair of COM2 --> VCP1 (COM2 is free and available). I switched it on, left vspk open (in another test I closed the program).
The tracking tool gets the message, the map software works fine, but the info won't go to COM2.

The same setup works perfectly on a T-Mobile MDA1 (also WM 2003) though.

Can you please help?

Thank you and
regards from Berlin, Germany
Thomas
Title: Re: Not working on Yakumo Omikron ?
Post by Andrew on May 24th, 2006, 3:22am
At first you need to define where is a problem. You can try to install the Serial and Telnet Communications Software in your Yakumo Omikron device. Look at here for example:

http://www.cam.com/vxhpc.html

Can you connect two copies of Serial Communication Software via virtual null modem pair created by our Virtual Serial Port Kit CE product and are you able to send/receive data via the such setup?